Recommendation Info About How To Check The Pilot Light

Here are the steps you should take when resetting your furnace:.

How to check the pilot light. Follow these steps to check the water heater pilot light: This will stop the flow of gas into the room. If you can’t see where the pilot light is, then look for the burner chamber door at the bottom of the heater and open the access door.

Once the steps have been. Locate the pilot light tube inside the burner. Then, turn the breaker on and open the main gas supply line.

To open the first door, pull the outer door off. A malfunction in the abs pump can cause the abs light to illuminate in pilot, and a fault code is stored in the memory. Steps to checking a furnace pilot light locate the panel cover on the furnace.

It should come off easily, but a screwdriver might be necessary. Use a flashlight to find the pilot or burner. To open the second door, slide it to the side.

If you still can't get the pilot to light, the most likely reason is a blockage in the pilot tube. You should be able to see a pilot light burning. The larger tube goes to the.

Turn your themostat to the lowest possible level (so it doesn’t turn on the furnace when you relight the pilot) locate the pilot in the furnace (is there a little blue flame. Turn the knob on your furnace to “off.”. Connect a diagnostic device to your vehicle to read the.